What work will be done before the charcoal powder briquette machine is turned on and used
Author: Admin View: Post Time: 2025 / 02 / 24
What work will be done before the charcoal powder briquette machine is turned on? When the charcoal powder briquette machine leaves the factory, in order to reduce the damage to the machine and injuries to personnel caused by improper operation, the manufacturer will indicate in the manual what needs to be remembered during operation. Regarding the content to remember, let the editor give you a detailed introduction below.
1. Remember not to check when starting the machine. In order to ensure the normal start-up and safe production of the coal rod equipment, the tightness of the screws, bolts and triangular belts should be carefully checked before starting the machine, and the machine should be started under foolproof conditions. If you do not check, the consequences of starting the machine may be unimaginable.
2. Remember to start the coal rod equipment with force. Sometimes, although the inspection was done before starting, and it was started with an empty car, the start-up was unsuccessful for some reason. If the start-up fails twice in a row, the start-up should be stopped and the fault should be eliminated before starting. If it is started forcefully, the motor is likely to burn out.
3. Remember not to feed and operate the coal rod equipment blindly.
The uniformity and continuity of feeding are very important. As an operator, you must adjust the feeding speed appropriately according to the current indication number (the current of the 220KW motor should be controlled between 350-400A, the current of the 90KW motor should be controlled between 150-165A, and the current of the 110KW motor should be controlled between 175-200A), and remember not to feed blindly.
4. Remember to operate the coal rod equipment at a close distance.
Safety is the key. In order to prevent the material from spraying and injuring the staff, it is strictly forbidden to stand within 10m in front of the machine head, and idle people are not allowed to enter the operation site.
5. Remember high hardness tools.
If the feed port of the coal rod equipment is blocked, it must be unblocked with tools. However, without stopping the machine, the unblocking tool is likely to be stirred in. At this time, if the hardness of the tool is high, it is likely to damage the coal rod equipment. In addition, if the hardness of the tool in the mixing is high, the operator may be injured.
6. Remember not to mix hard objects into the raw materials.
The coal rod equipment uses coal powder as raw material and is processed into coal rods with a certain strength through the principle of extrusion molding. During the processing, if there are hard objects mixed in the raw materials, it is easy to damage the extrusion part, so hard objects cannot be mixed in the raw materials.
7. Remember not to work in fatigue. After the coal rod equipment has been working continuously for a period of time, the motor will heat up. When the temperature rises to a certain degree, it will enter a fatigue state. Once it enters the fatigue state, not only the power conversion rate will decrease, but it will also be easily burned out if the temperature increases slightly. Therefore, after using it continuously for several hours, you must stop the machine and rest for a while. Remember not to work in fatigue. For your safe production efficiency, please use the carbon powder molding machine correctly. To avoid unnecessary losses.
If you are interested in our products , please send inquiry to our email:Alisa@lantianmachine.com
HOME
PRODUCTS
CONTACTS